Linplug Organ 3 Manual do Utilizador

Organ 3Drawbar OrganUser Guide

ControlsUsers have the option of controlling Organ 3´s dials in either a circular or a linear manner depending on the Dial Mode setting, located under

The Main SectionThe “Main Section” of Organ 3 is located on the left side of the user interface. This section contains the drawbars, the three manual

The Spread dial controls the intensity of the polyphonic unison, creating a sound as if several organs were played simultaneously. Turning the Spread

The “Drawbar” SectionThe Drawbar Section is the most important part of Organ 3, as this is where the instrument's overall sound is determined.

16" the sub-octave -12 semitones 0.5th harmonic5 1/3" the fifth +7 semitones 1.5th harmonic8" the fundamental4" the octave +12 s

a violin tone. Drawbar setting (00 6876 540) is an example of a trum-pet-like tone, and Drawbar setting (54 5444 222) is an example of an or-gan-like

“Organ 3 Banks” directory. You can select a different Bank by left-clicking on the Bank name. „Presets“: the preset name is displayed for your referen

The „Organ“ pageThe “Organ” page is located on the right side and is accessed by clicking the “Organ”-tab. The “Organ” Menu contains the controls o

The Vibrato SectionThe Vibrato section is located in the middle of the “Organ” Menu. The controls in this section are used to add vibrato and tremol

The Master SectionThe Master Section is located under the Vibrato Section. It contains controls for Click, Motor, Age, Drive, Bright

Copyright LinPlug Virtual Instruments GmbH 2006-2014All rights reservedInstrument Peter Linsener & Pavol MarkovicSounds Big!Tone (BT), dubhad(DH),

„Body“: further changes the sound of “Drive”, too. It functions like a Highpass-Filter. The small indicators above the controls for Click, Moto

„Time” controls how fast the pitch “glides” from one note to the next one. To the right of the Time dial is the on/off/held control. On/off simply tur

Norm: the three manuals receive on individual MIDI-channels. If the MIDI-Channel in the “Settings” Menu is set on channel

Spl 1: Upper and Lower Manual are “split” at the split points which are defined in the “Settings” Menu. At the split point and above you hear the Uppe

Off: switches the ECS learn- & clear-mode off.Learn: activates the ECS-learn mode. Don’t forget to switch “Learn” off after assigning combinatio

RotaryThe „Rotary“ effect simulates the sound of a Leslie Speaker Cabinet. The original Leslie speakers that usually accompanied the B3 consisted of a

FAS: sets the speaker rotation to the fast speed settings.To the right of the on/off, SLO and FAS buttons are the dials for the speed and acce

An example for acceleration settings: If “lo accel” is set to 1/1, “hi accel” to ½ and you switch the speed of Rotary from slow to fast, the acce

ReverbThe Reverb effect is used to add ambience to the sound. It features the following controls:predelay: the predelay dial enables you to delay the

diffusion: The diffusion control is used to set the number of diversion stages that are applied to the input signal. As the value of the dif contro

WelcomeThank you for licensing Organ 3!In the late 1930s, Hammond released the B3 organ. Since then, the sound of the Hammond B3 has become

delay dial. right: the right dial is used for setting the right delay time. The delay time can be synched to the song tempo using the pop up menu bene

ChorusThe Chorus effect can be used to "thicken" a single sound creating the impression that it contains multiple voices. The Chorus works b

GatorThe Gator effect is a step-controlled audio gate that can be used to cre-ate rhythmic, stuttering and pulsing effects. The effect is unique in th

other will be off. In this case only one of the two left and right channel buttons can be switched on at the same time.sync: the sync control sets t

CrusherThe Crusher is a distortion effect that combines bit-depth and sample-rate reduction allowing the resolution of the signal to

reso: reso(nance) is used to set the amount of emphasis around the cutoff frequency. Higher settings create a more pronounced peak in the signal

The „Settings“ pageThe Settings page is located on the right side of the user interface. You open it by clicking the “Settings” tab. The following con

also able of sending MIDI-data. Sending MIDI-data is especially useful when using a MIDI-controller like the Doepfer d3c, the Native

Three of them are basic waveforms: sine, triangle and sine/triangle (a mixture of sine & triangle). Ther others are different sample sets of the B

the tonewheels jumped one octave lower. When you activate the Foldback button the drawbars of Organ 3 behave like those historical

Table of ContentsINSTALLATION... 5OVERVIEW...

EnvelopesAn envelope is a time-varying signal used to control the development of another signal after it has been triggered. Envelopes are most often

Split Points & OctaveTo the right of the Envelope dials are the controls for setting the manual’s split points as well as the octave. The one-digi

Appendix A: MIDI Implementation ChartProduct: LinPlug Organ 3 Version 3.x Date: 27.Oct 2006 Manufacturer LinPlug Virtual Instruments GmbHFunction Tra

Appendix B: Predefined ECS assignmentsThe following MIDI-CC-parameter-assignments are automatically set up on start-up of Organ 3. Of course, the assi

Appendix C: Sync settingsOff, 1/2, 1/2T, 1/4*, 1/4, 1/4T, 1/8*, 1/8, 1/8T, 1/16*,1/16, 1/16T, 1/32*, 1/32, 1/32T.Note: "T" stands for Triple

Appendix D: Using TUN FilesBy Jacky LigonAbout Microtuning Microtuning, or "microtonality" are methods for tuning musical inst

The Scala home page is http://www.xs4all.nl/~huygensf/scala/Specifying the Reference Frequency of a MicrotuningOne of the powerful capabilities of the

InstallationInstallation on MacThe LinPlug Organ 3 comes with its own Installer. After downloading the Organ 3 you will find a file named "Organ

OverviewOrgan 3 is a 64 note-polyphonic* drawbar organ with some extraordinary features. It is based upon the classic drawbar organ

The “Effects” Section contains all controls of the dual-effects processor.In the “Settings” menu you find the Master Tune, MIDI-sett

Amplifier (Drive) section. The output of the Amplifier (Drive) section is then sent to the dual-effects processor. In the “Master Section” you can al

What’s new in Organ 3· now 3 individual manuals (Upper, Lower, Pedal)· manual settings can be saved/loaded and copied/pasted· Percussion - se